Click through to watch this video on easy2diy. Want to master Microsoft Excel and take your work-from-home job prospects to the next level? Jump-start your career with our Premium A-to-Z Microsoft Excel Training Bundle from the new Gadget Hacks Shop and get lifetime access to more than 40 hours of Basic to Advanced instruction on functions, formula, tools, and more.
Install a drop-down attic stairway Click through to watch this video on easy2diy. Subscribe Now. Share Your Thoughts Click to share your thoughts. When located in a wall, the width must not be less than 22 inches and the height not less than 30 inches. When located in a ceiling, a minimum unobstructed headroom clearance must be provided. If the staircase you are installing provides a safer and better means of egress to a floor, you will not need to meet building code.
All loft conversions must comply with building regulations, even if the type of conversion you are having means planning permission is not required. A fixed staircase must be in place to provide safe access to and from the loft room.
The staircase can have a maximum steepness pitch of 42 degrees. It most certainly does. The more storage space your home has to offer, the more value is added to you home. SeniorCare2Share Care about seniors? Have knowledge? Use a cordless drill if an electrical outlet is not available. Include wood shims and a hammer. Determine the direction that you want the stairs to pull down.
Position the closed drop-down unit on the floor with the hinges, springs and folded staircase facing up and the outer end of the stair stringers facing the direction it will pull down. Use the stepladder to take the other end of the rope to the area above the ceiling. Pull upward on the rope as the assistant lifts the opposite end of the unit onto the top of the stepladder. Pull upward on the rope, and grip the frame at that end of the unit with both hands. Coordinate with the assistant as you place the unit in the opening with each end resting on a temporary support.
Install wooden shims in the gaps between the outer edges of the frame and the adjacent ceiling framing at both sides and both ends of the unit. Tap the upper ends of the shims in equal increments with the hammer to center the frame each way in the framed opening. Now install the top three stair treads. Slide the steel door-guide frame onto the staircase, then attach it to the door panel with six 1-inch-long screws.
Using the pilot holes located near the fourth tread, mount cable holders to the side of each stringer. Reach up to one of the spring drums, grab the cable closest to the header and carefully pull it out. Pull the cable across the small pulley and down to the cable holder mounted to the door. Hook the cable end onto the holder.
Use the same procedure to connect the cable from the drum on the other side of the stair. Adjust the tension on the cables until the staircase glides smoothly up into place and closes without slamming shut. If the door doesn't close all the way, increase the tension by disconnecting the cables, winding them around the spring drums two times; then reconnect them.
Finish by nailing casing molding around the perimeter of the opening; paint it to match the ceiling. Cookie banner We use cookies and other tracking technologies to improve your browsing experience on our site, show personalized content and targeted ads, analyze site traffic, and understand where our audiences come from.
By choosing I Accept , you consent to our use of cookies and other tracking technologies. By Joseph Truini. Pinterest Email Pocket Flipboard. Step 1 Cut out attic access opening Photo by Karim Shamsi-Basha Snap chalk lines onto the ceiling to represent the rough opening of the attic staircase.
Step 2 Remove joists and other obstructions Photo by Karim Shamsi-Basha Cut out the ceiling joist and any wood blocking that's in the opening. Step 3 Construct the opening frame Photo by Karim Shamsi-Basha Temporarily screw a pair of 1x3 cleats to the ceiling across the rough opening.
0コメント